| Step | | Procedure & Parts & Tools |
| 1 |
|
PULL TO REMOVE THE RED CAPPED HOSE FROM MACHINE. PLACE HOSE NEAR DRAIN AND REMOVE CAP
|
| 2 |
|
PULL TO REMOVE THE BLUE CAPPED HOSE FROM MACHINE. PLACE HOSE NEAR DRAIN AND REMOVE CAP
|
| 3 |
|
REMOVE THE 2 TANK BOLTS ON EACH SIDE OF THE MACHINE. THESE BOLTS ARE LOCATED AT THE FRONT OF THE MACHINE AT THE BASE.
| Wrench-Allen metric 6.0mm |
|
|
| 4 |
|
OPEN THE MACHINE AND REMOVE THE BATTERIES.
|
| 5 |
|
LAY THE MACHINE ON ITS SIDE
|
| 6 |
|
LOCATE THE HOSE BETWEEN THE SOLENOID VALVE AND THE DECK
|
| 7 |
|
LOOSEN THE HOSE CLAMP SCREW TO LOOSEN THE HOSE CLAMP
| Screwdriver-flat tip |
|
|
| 8 |
|
SLIDE THE HOSE CLAMP DOWN ON HOSE (SAVE THE HOSE CLAMP)AND PULL TO REMOVE HOSE
|
| 9 |
|
PULL TO SEPARATE THE HOSE FROM THE "T" CONNECTION
|
| 10 |
|
REMOVE THE 3 BOLTS FROM THE SHROUD
| Wrench-Allen metric 5.0mm |
|
|
| 11 |
|
LOOSEN THE HOSE CLAMP SCREW TO LOOSEN THE HOSE CLAMP
| Screwdriver-flat tip |
|
|
| 12 |
|
SLIDE THE HOSE CLAMP DOWN ON HOSE (SAVE THE HOSE CLAMP)AND PULL TO REMOVE HOSE FROM THE BRUSH DECK. PULL THE HOSE FROM MACHINE
|
| 13 |
|
REVERSE STEPS 3 THRU 12 TO INSTALL A NEW HOSE (SOLD BY THE INCH)
|